Hi All - Did a lot of searching and did not find an answer to my question.
I had a 64,000 grain Pentair system installed in November 2021. The brine tank accepted around 10 or so 40lb bags of salt at install. We're a family of 6 and our home has 2 full baths and a half bath. We're outside Buffalo.
So far I'd say 2x40lbs bags, maybe 3, have been used. I expected to have used far more salt by now. How can I know if the system is working properly? Maybe my water isn't THAT hard so it's not using as much?
I did find many posters talking about salt bridge. I checked and do not have a salt bridge. You can see the water in the brine tank just barely below the top of the salt.
Thanks in advance for any input!
I had a 64,000 grain Pentair system installed in November 2021. The brine tank accepted around 10 or so 40lb bags of salt at install. We're a family of 6 and our home has 2 full baths and a half bath. We're outside Buffalo.
So far I'd say 2x40lbs bags, maybe 3, have been used. I expected to have used far more salt by now. How can I know if the system is working properly? Maybe my water isn't THAT hard so it's not using as much?
I did find many posters talking about salt bridge. I checked and do not have a salt bridge. You can see the water in the brine tank just barely below the top of the salt.
Thanks in advance for any input!