Nelsen Softener Head power Options "P" "B" "S"

Users who are viewing this thread

Total: 3 (members: 0, guests: 3)
Waterboy99

Waterboy99

New Member
Messages
7
Reaction score
0
Points
1
Location
Tampa
Hey folks, I have what I think is a Metered Nelson head on my Softener inside there are 3 options as to where the power source plugs in to, label "P" "B" "S". Can anyone help me identify where I should plug the power, and if by chance tell why they have three choice. I ask this because I was getting lots of air in the water after regeneration, so when I switched from "S" to "P" but now the water doesn't seem soft. I'm confused.

Thank you very much for your help.
 

Attachments

  • 20210626_115302.jpg
    20210626_115302.jpg
    40.3 KB · Views: 128
You must log in or register to reply here.

Similar threads

B
Help Needed - Clack WS-1 Brine Tank Full of Water, Messed Up Settings, and Other Issues
Replies
0
Views
1K
brawbridge
B
J
Navien NPE-240A2 x2 units--please help me configure
Replies
12
Views
2K
Fitter30
Fitter30
diytaylor
Help + Advice Needed Please! Air Gap Leaking from Backwash Drain Lines
Replies
0
Views
1K
diytaylor
diytaylor
grayhair54
New Softener System - head replacement suggestions?
Replies
4
Views
1K
grayhair54
grayhair54
Gtown homeowner
Replacing Water Fittings for F&P Integrated French Door Refrigerator
Replies
9
Views
2K
hj
hj
Top
✖
Hey, wait a minute.

This is awkward, but...

It looks like you're using an ad blocker. We get it, but (1) terrylove.com can't live without ads, and (2) ad blockers can cause issues with videos and comments. If you'd like to support the site, please allow ads.

If any particular ad is your REASON for blocking ads, please let us know. We might be able to do something about it. Thanks.
I've Disabled AdBlock    No Thanks