Wes
New Member
We recently had an addition put on the house and a new heating zone added. We have an oil furnace that supplies heat and hot water. While the plumber was here the last time he decided to "fix" things on the temperature settings.
Unfortunately, I don't remember what the Honeywell controller was set to before he "fixed" it even though I looked at it just a few months ago.
Everything used to be fine... NOW, our how water just isn't hot enough. I can have the shower or kitchen sink set to the middle position and the water will be fine. Then in a few minutes it cools off!
The middle position used to be fine and would stay fine the entire time the water was running.
Right now it's set to 180/140 with a diff of 15. I think it used to be 130/160 but I don't remember the differense setting.
Any recommendations?
thanks
Wes
Unfortunately, I don't remember what the Honeywell controller was set to before he "fixed" it even though I looked at it just a few months ago.
Everything used to be fine... NOW, our how water just isn't hot enough. I can have the shower or kitchen sink set to the middle position and the water will be fine. Then in a few minutes it cools off!
The middle position used to be fine and would stay fine the entire time the water was running.
Right now it's set to 180/140 with a diff of 15. I think it used to be 130/160 but I don't remember the differense setting.
Any recommendations?
thanks
Wes