-Finished Nipples-

Users who are viewing this thread

Chefwong

Member
Messages
949
Reaction score
11
Points
18
Location
District of Columbia
What tools are you guys using for finished (chrome) 1/2 nipple. Slip joint pliers and rubber, old hose, etc
I have a pair of slip joints with plastic jaws but I find the grip meh t times, so I end up just putting. old hose on it, and grip it with a regular slip joint

Was looking at it, but needed to do a deeper dive. Does Spud Wrenchs in this small of a diameter exist and work well

I know there is the opposite, internal wrenches but are threaded one way I believe and mainly used to back out/remove in the cut of the threading.
 

Marlinman

In the Trades
Messages
915
Reaction score
427
Points
63
Location
Jacksonville Florida
This is the best I have ever used. Sold as Wilde and Wheeler-Rex


1674596317946.png
 

John Gayewski

In the Trades
Messages
5,092
Reaction score
1,645
Points
113
Location
Iowa
I think most people tighten them with the stop. Instead of grabbing the nipple with anything put whatever is going on the nipple, onto the nipple and use it to tighten the nipple.
 
Top