BobSmith
New Member
- Messages
- 22
- Reaction score
- 0
- Points
- 0
Any suggestions?
I solvent welded a single, 1 1/2 inch compression fitting to my stub out and installed all of my cabinets prior to learning that per local code I need a trap for each bowl of my double bowl sink if I am going to have a garbage disposal. The gents at Homers suggested a 3 X 1 wye with a plug in the center outlet, but I only have about 3/4 of an inch of excess pipe.
Would I be able to put some type of threaded connector on the existing fitting and then weld on the wye? Or is there something else that would work short of not installing the disposer? Thanks.
Bob
I solvent welded a single, 1 1/2 inch compression fitting to my stub out and installed all of my cabinets prior to learning that per local code I need a trap for each bowl of my double bowl sink if I am going to have a garbage disposal. The gents at Homers suggested a 3 X 1 wye with a plug in the center outlet, but I only have about 3/4 of an inch of excess pipe.
Would I be able to put some type of threaded connector on the existing fitting and then weld on the wye? Or is there something else that would work short of not installing the disposer? Thanks.
Bob