Going a bit nuts here and my lack of experience is getting in the way.
Replacing 3 switches - 2 older 2 wire Leutron dimmers and a leutron 3 wire dimmer [which is also controlled at the other end of the kitchen. This 3 way switch has contrasting orientation.]
new switches are Insteon home automation type dimmers (2477D). The Insteon's have red/white (load) black(line) and bare copper ground wires.
I was able to get the 3 way working (far right) but having problems integrating the other 3 wire Insteons to the existing 2 wire setup that the leutrons had.
See pic. The other 2 standard 2 wire dimmers we're just pigtailed to a line and separately to loads, seems i've not completed the circuit.
My 2nd new switch (1st on left) has power but will not control light, ive not integrated the 3rd new switch yet- old leutron in in the middle
Replacing 3 switches - 2 older 2 wire Leutron dimmers and a leutron 3 wire dimmer [which is also controlled at the other end of the kitchen. This 3 way switch has contrasting orientation.]
new switches are Insteon home automation type dimmers (2477D). The Insteon's have red/white (load) black(line) and bare copper ground wires.
I was able to get the 3 way working (far right) but having problems integrating the other 3 wire Insteons to the existing 2 wire setup that the leutrons had.
See pic. The other 2 standard 2 wire dimmers we're just pigtailed to a line and separately to loads, seems i've not completed the circuit.
My 2nd new switch (1st on left) has power but will not control light, ive not integrated the 3rd new switch yet- old leutron in in the middle