Hi guys,
I have a new vacuum pump (Vacutronics DV-5V 110V oil less vacuum pump) that will be used for a vacuum chuck system on a lathe. It did not have a power cord wired onto it, and I'm a bit stumped as to how to wire one into this unit. Can someone please advise as to what my best steps would be for determining how to wire a power cord to this thing? There are two terminals that are associated with red wires, as shown in the attached picture. That's it as far as I can tell. Thanks in advance for any help you can provide.
Cheers,
Paul
I have a new vacuum pump (Vacutronics DV-5V 110V oil less vacuum pump) that will be used for a vacuum chuck system on a lathe. It did not have a power cord wired onto it, and I'm a bit stumped as to how to wire one into this unit. Can someone please advise as to what my best steps would be for determining how to wire a power cord to this thing? There are two terminals that are associated with red wires, as shown in the attached picture. That's it as far as I can tell. Thanks in advance for any help you can provide.
Cheers,
Paul