culligan

Hi, All, We have a Culligan softminder twin system which was put into the house by original owner at around 2003. We haven’t used it since we moved in back in 2016. Earlier this year, we started using it since kids started complaining that water left stains/residues at their shower. About a...

Got a 2005 Culligan Medallist 8" softener (think this link to pdf manual is for it) that came with our house, hooked up to city water, think it's giving me issues. Few months back we were having intermittent loss of water pressure for maybe a 3 week period, only hot water though, but it'd only...

I am set to close on a house the end of this month but the well water is creating a bit of a problem and I'm trying to figure out how much it will cost and how to remedy it. I'm also interested in brand suggestions. TDS: 850ppm Hardness: 31 gpg Iron: .8 ppm Manganese: 0 pH: 5.6...

I am looking to replace my gold series Culligan with something else. I am leaning towards Fleck but open to other options. Culligan came out and recommended to replace my current with an HE1 10". The pricing was just outrageous. I have been looking at the Fleck 5600SXT, 5810SXT and the 5810...

I have a Culligan Gold Series Water Softener system. My resin tank (9x48) was leaking and I bought a generic replacement. Of course, the resin tank adapter/coupler (which sits between the tank and the control head) has a different thread size (propriety to Culligan) than the generic tank...

Hi All, New here to this site. A lot of great stuff to glean from as I'm a DIYer. Okay onto my question, which may have been answered already, but here it goes. I have a Culligan Iron Clear Filter (2 tanks). I'd like to re-bed it but can't seem to get Culligan to just sell me the material...

First post from an inexperienced DIYer. Professional advice here in the post and in future ones is GREATLY appreciated. A Culligan Medalist control valve began leaking from a side seam where a top plate meets the bottom assembly. This leak is not at any connection point for any pipes or...

18 year old Culligan Silver Series. Long story short: Stopped producing soft water about 4 mos ago I replaced the resin with an appropriate product and amount Water was soft for about a week, then hard again (by feel and also test strips) The unit still consumed salt despite hard water Used...

I want to replace the sand and carbon media in the tank and reseal this older unit for my Dad. I've read all the threads here on this model and watched all the YouTube videos I could find, and have downloaded the Super S installation/operators manual from several sources... But none of them...

We had a low flow issue in the whole house. It was not a filter problem. The bypass was plugged on our Culligan Super S. A plumber removed the entire top assembly, cleaned the bypass and full flow was restored. He left leaving the valve in bypass. I started to transfer the valve and water shot...

Hi, I'm paying through the nose to rent a system from Culligan that isn't doing the job. I've called them out twice in the past 1.5 years and both times they've told me the water is fine. Trouble is, I'm still using a filter on the tap in the kitchen because the water smells metallic and leaves...

I just repaired this unit 3 or 4 months ago. Now a new issue has arisen. After a recent recharge cycle there is a constant trickle into the discharge drain (I've had to bypass it to conserve water). Either a valve diaphragm has perforated or some check valve or gasket has given up. I found a...