boiler

  1. Mike Vavricka

    Basement Radiant Floor System Boiler

    Hello, I am finally diving into utilizing the pex tubing in the slab for our basement versus the duct work from the forced air gas furnace. After finishing the basement last winter and spending more time down there this winter we would like to improve the comfort level during the heating...
  2. Technophile

    Hydronic heating. When should the pumps run?

    Hello! We have a hydronic heating system that appears (to my admittedly inexperienced eyes) to have some design and installation errors (no filter, expansion tanks undersized and upside down, air eliminator in the heating return instead of between the boiler and circ pump, ...). I would...
  3. Tangent

    Best High setting on boiler aquastat

    My boiler Aquastat is set to a High Temp limit of 180 F. Some folks say you get better efficiency by running at a slightly higher temp, like 190 F. What does your experience tell you? https://inspectapedia.com/heat/Aquastat_Settings.php ___ "Generally a heating boiler is more efficient if...
  4. ShawnW123

    Navien NHB Series Boiler - Error Code 291

    I have a Navien NHB series boiler that produces an error code 291 about 5 minutes into its call for heat. Boiler fires, pump activates, hot water begins to flow and the temp readout gets to 104 (which is the setting for this unit as it is heating a cement garage slab). I spoke to a Navien tech...
  5. Aron Golden

    Navien 240 combi

    Two story house with two thermostats. Upstairs works, downstairs pumps unheated water through radiators regardless of thermostat setting. Valve? Pump? This will be the 12th repair in 6 years for this unit. Getting frustrated and going broke!
  6. Scott Thomas

    Help Sizing Replacement Boiler

    Need advice on sizing a replacement boiler for my home. I believe I need a smaller boiler, however I am not a professional and obviously could be wrong. My contractor is insisting on installing a new boiler of the same size. He believes the replacement must be equal in output to the existing...
  7. Kaspars

    Boiler leaking through side.

    Dear Gentlemen, I'll be short: I'm not very knowledgeable in the boiler side of things, although I'm technically inclined and am reading up on boilers as we speak. I have an acute problem, that I have to fix miself due to budgeting issues - I can't afford to change the boiler or anything of...
  8. Joe the Plumber

    My boiler is under water, what now?

    I don't understand why it's so hard to relight my boiler. It's almost like it's underwater or somthin. I picked up some matches at a restaurant. They had the name of the restaurant on them but I figered that should be okay. If I strike a match and it falls then all I hear is a sizzle and...
  9. Vinny

    Boiler question.

    hello everyone. I’m a plumber for many years but mostly work in new construction projects. My hot water boiler safety relief valve was leaking. I noticed it stopped leaking and the pressure dropped to 5 PSI. I opened the pressure reducing valve and it brought the pressure way past 30 and was...
  10. RinCT

    Burner didn't shut off at limit

    Newbie here. I just noticed my Oil Fired Burnham Boiler wasnt shutting off when heat runs. I turned Tstat down so it stopped. Went to check temp and it was almost 200 with pressure rose to 20psi. Normally at 15. I have Hi/Lo set at 180/150 and diff at 12. Maybe I never noticed before but why...
  11. Joe Henderson

    Boiler short cycling

    Hi my boiler keeps short cycling .. I think it might be because my thermostat looses its temperature very fast.. if I have it set to say 68 And it’s 67 or 68 my boiler will turn on for a minute then turn off then the will go back on in about 3 min when the thermostat goes down by one ,, can I...
  12. mehmet sarikcioglu

    Help Utica boiler

    Hi I have a utica natural gas boiler that is about 10-15 yrs old (my guess) Recently bought house and my first concern was that the boiler water gets up to temp which is 180 and shuts off while there is still a call for heat. In my last home i would remember the boiler would run until it...
  13. Stallion81

    Replacing a Weil Mclain CGA6 and expansion tank

    Hello all new to the forum. I do concrete for a living so bear with me. My expansion tank (plain steel) was leaking at the end of the year from the top, and my boiler also blew a leak. I'm assuming it was a combination of things including my auto fill valve. System was running correctly even...
  14. samuel_a

    Need help with Boiler Selection and Sizing

    Hey Guys, I live in Eastern Massachusetts and my home is around 2900 sq ft. I bought this home last year during fall (Built 1988) and my last winter gas bills were skyrocketing. I knew that I had to replace the boiler at some point when I purchased the home but looking at the last year winter...
  15. Michael Harner

    Replacing Baxi Luna 310 with Viessmann 35 Combi

    My baseboards produce 75,000 BTU using 1660 per foot. Three contractors all want to use Viessmann. What negotiating points can I ask for? I'm keeping my two thermostats. How many annual free maintenance calls are reasonable? Isn't $6900 quite high using existing plumbing and gas lines? What...
  16. heytom

    Stainless Steel Softener Resin Tanks

    I am brainstorming how many condo owners have in the past on how to add a water softener when the condo has a central hot water boiler. I understand I would have to have a softener for both the cold water and hot water sources in my condo that come in under the master bedroom sink. Without...
  17. Ki23

    Tri-level replacement

    Good morning all, I've been reading these forums for weeks and getting great information from them. My situation is a little different as I have a 1978 tri-level house that has a furnace on the second floor only so we can remove that from the equation, I believe. I know how many therms I used...
  18. sakle2k

    Trying to determine the best boiler replacement

    Hello all, I've been reading this forum quite a bit in the past week and have realized how important it is to have a knowledgeable person installing your boiler. I'm hoping to get a better understanding of what my needs are so I don't make a mistake. I have an old Weil-Mclain boiler that I'd...
  19. Jah1010

    Trouble Draining the Boiler

    Hi all, I bought this house recently and am still learning the systems. I have a 2 zone, oil-fueled hydronic heat system, and the circulator pump just broke (or rather, is breaking). I have a new one and am ready to install it. My plan was to drain the system from the drain valve (bottom circle...
  20. Syt0x

    New To Hydronics Have Questions About New House Boiler System

    Hey everybody I've got another question for the amazing people on this forum that will hopefully be easy for one of you experts to answer as it will hopefully be just an informational adventure for me. I've recently replaced the temperature pressure relief valve, expansion tank, and auto air...
Top
Hey, wait a minute.

This is awkward, but...

It looks like you're using an ad blocker. We get it, but (1) terrylove.com can't live without ads, and (2) ad blockers can cause issues with videos and comments. If you'd like to support the site, please allow ads.

If any particular ad is your REASON for blocking ads, please let us know. We might be able to do something about it. Thanks.
I've Disabled AdBlock    No Thanks