TMLFan
New Member
- Messages
- 2
- Reaction score
- 0
- Points
- 0
I have replaced my single kitchen sink with a sink & a half model.
In order to hook up the drain, I purchased a continuous waste, center outlet kit to "simplify" the installation, as I figured I could hook directly to the drain, without using drain flange.
I now notice that there is about a 3/4 inch difference in the drains of each bowl, so it is impossible to connect the continuos waste kit.
Is there any ABS fitting I can use to make up this height difference or do I need to build the entire drain assembly myself.
Thanks
In order to hook up the drain, I purchased a continuous waste, center outlet kit to "simplify" the installation, as I figured I could hook directly to the drain, without using drain flange.
I now notice that there is about a 3/4 inch difference in the drains of each bowl, so it is impossible to connect the continuos waste kit.
Is there any ABS fitting I can use to make up this height difference or do I need to build the entire drain assembly myself.
Thanks