Hey all,
Quick questions here.
1. I'm installing a shower body valve with the plaster guard. If I set the plaster guard correctly where the CBU and the tile are flush with the plaster guard, this means when I'm installing the rest of the trim pieces later, I won't have a problem correct?
2. I'm going to use these 90 degree elbows with threads on one side for the drain spout and the shower head. How do I gauge how deep this will be with the spout and shower head? Or should i buy the ones without the tabs/ears? I know I have to set a 2x4 or something so it doesn't move but I don't this to protrude out too much or recessed where I can't get to it.
Thanks!
Quick questions here.
1. I'm installing a shower body valve with the plaster guard. If I set the plaster guard correctly where the CBU and the tile are flush with the plaster guard, this means when I'm installing the rest of the trim pieces later, I won't have a problem correct?
2. I'm going to use these 90 degree elbows with threads on one side for the drain spout and the shower head. How do I gauge how deep this will be with the spout and shower head? Or should i buy the ones without the tabs/ears? I know I have to set a 2x4 or something so it doesn't move but I don't this to protrude out too much or recessed where I can't get to it.
Thanks!
Last edited by a moderator: