Hello all, I have an RO system similar to the one in this set up - http://www.wattspremier.com/troubleshooting-layout.htm - It has the faucet as shown to the right of the circled 8.. I 'think' it is referred to as an Air Gap faucets since it has a small hole near the bottom that connects to a thin tube.
here is my problem..
Twice in the last few weeks the faucet has started flowing water out the small hole near the base of the faucet. I turn the supply off and it stops, let it sit overnight and turn the supply back on and there was no problem for a couple days until it started doing it again. The flow of water is strong enough that it squirts out horizontally for about an inch and a half and produces enough water to flood the counter top in just a couple minutes.
What would cause the system to back up and pump water out of that little hole?
Thanks for any input in advance...
here is my problem..
Twice in the last few weeks the faucet has started flowing water out the small hole near the base of the faucet. I turn the supply off and it stops, let it sit overnight and turn the supply back on and there was no problem for a couple days until it started doing it again. The flow of water is strong enough that it squirts out horizontally for about an inch and a half and produces enough water to flood the counter top in just a couple minutes.
What would cause the system to back up and pump water out of that little hole?
Thanks for any input in advance...