Thomas D Brown
New Member
Had new pump installed last summer a 3/4 10 gpm . Along with a few sections of pipe that had holes in them . I just changed pressure switch on tank today 40/60 , it's a 82 gallon galvanized tank with a float has a date stamp of 11/1961 , pump stays running at about 50 psi until I try and start another sprinkler and then it causes pump to cycle from 40 to 60 back and fourth . Any suggestions where to go from here? I would love to run multiple sprinklers. The well depth I believe is 120 to end of submerged if Ipump/pipe if I remember correctly. I took a 5 gallon bucket and can fill it up within 27 seconds so that tells me I'm getting my 10 gpm roughly thanks for any advice