Hi all - looking for some guidance on what to do in my back to back shower remodel project. I redid plumbing to have side #1 traditional (hot left / cold right) and side #2 has the reverse (just copied what was existing). I will note that I could redo plumbing to make side #2 traditional but trying to explore other solutions before cutting out the relevant section to cross back over to traditional.
I am using delta multichoice valves on both side so flipping the cartridge 180 degrees is not an issue for side #2.
The problem I am having is on the trim kits. They all seem to have the writing oriented to standard (duh) and I am not seeing a great solution to accommodate side #2 other than putting the face plate upside down? Am I missing something obvious here?
This is my first shower project so thanks for the help!
I am using delta multichoice valves on both side so flipping the cartridge 180 degrees is not an issue for side #2.
The problem I am having is on the trim kits. They all seem to have the writing oriented to standard (duh) and I am not seeing a great solution to accommodate side #2 other than putting the face plate upside down? Am I missing something obvious here?
This is my first shower project so thanks for the help!