Search results

I have a non submersible water pump to move water from a creek to water storage tank. I ran it out of gas a couple times and noticed it had trouble restarting. I fully ran it out of gas today and now can't get it to start. Is there air stuck in the fuel line or something else broken here? Thank you.

Hi, I'm trying to setup a hydraulic water ram pump. I have about 30 ft of 2" PVC feeding into the pump. It's around 2-3 ft above the ram pump. My issue is the ram check valve is not burping. I don't know if there is an air leak or just not enough pressure flowing into the pump.

I have a hand rotary auger and when I hit the water table the sand collapses on the auger. How do I add bentonite to the bore whole to keep the walls from collapsing? Can I just pour the mud slurry in while augering? Thanks

I've heard a few people discuss driving two wells and then combining them for more yield. Can anyone describe the pump system for this? If I have two 2" wells driven to 18ft, then the pump would need suction power of at least 40ft if they are both tied to the same line. Most pumps I've...

I was able to get 12' of pipe driven with a heavy 3.5" post driver. At this point of depth, it looks like I've hit the wall on its ability to driver further with it's weight. What do you guys suggest I use to get this pipe deeper? There's a rental place down the street with a gas powered US...

I have a 1.25" steel pipe driven 15ft with a static water level at 6ft below. So the pipe is about 9ft below the water table I installed a 3/4 PVC pipe with a foot valve at the bottom. I topped of the PVC pipe with water and then I tried to attach a drummond 1/8 hp transfer pump. It did not...