rural_engineer
In the Trades
My well pump operates on a 50/70 pressure switch and I have a 60PSI CSV in my well, which seems to give just over 50 PSI at the house when the water runs continuously. (It's about 16-18' vertically from the well to the house.) My plumbers aren't very knowledgeable, and I believe installed the pressure tank and the hot water expansion tank without setting the pre-charge.
I believe the factory pre-charge is 50psi for the thermal expansion tank, and 40psi for the well tank. Have I damaged or am I going to damage the tanks by operating as-is for a while?
I believe the factory pre-charge is 50psi for the thermal expansion tank, and 40psi for the well tank. Have I damaged or am I going to damage the tanks by operating as-is for a while?