Im trying to fix my water softener. I noticed my last shower I didn't have soft water. I checked to see if it needed salt. It was full. I have a Fleck 5600sxt that displayed error 1. I tried to do a force regen. It started but error 1 came back. What would be my next step? I am ready to disassemble just need to know what Im looking for.
Fleck 5600sxt Error 1
- Thread starter jness
- Start date
Users who are viewing this thread
From page 35 of the service manual.... troubleshooting section:
1 Cycle Step Error
The control experienced an unexpected cycle input
Unplug the unit and examine the powerhead. Verify that all cam switches are connected to the circuit board and functioning properly. Enter Master Programming mode and verify that the valve type and system type are set correctly with regard to the unit itself. Step the unit through a manual regeneration and verify that it functions correctly. If the error re-occurs unplug the unit and contact technical support.
1 Cycle Step Error
The control experienced an unexpected cycle input
Unplug the unit and examine the powerhead. Verify that all cam switches are connected to the circuit board and functioning properly. Enter Master Programming mode and verify that the valve type and system type are set correctly with regard to the unit itself. Step the unit through a manual regeneration and verify that it functions correctly. If the error re-occurs unplug the unit and contact technical support.
Similar threads
