Gravity
New Member
Hi, I was going to install shutoff valves on existing 1/2" brass cold and hot water lines. Can I use valves with 1/2" compression inlets? Do they play nice with brass pipe? Or should I use 1/2" sweat connection?
If I sweat it, is there any need to modify my copper pipe soldering technique for brass pipe?
Thanks!
And before anyone mentions it, I know PEX is awesome and the greatest thing since sliced bread, blah blah blah but it isn't in the budget for this renno.
If I sweat it, is there any need to modify my copper pipe soldering technique for brass pipe?
Thanks!
And before anyone mentions it, I know PEX is awesome and the greatest thing since sliced bread, blah blah blah but it isn't in the budget for this renno.