Canuck Fan
New Member
My neighbour is an older guy who isn't very handy and he asked if I can do him a favour. His bathroom faucet was dripping slowly but constantly and he asked if I could have a look at it as I'm an apprentice plumber (no service experience thought, just over a year building highrises) I figured that the rubber washer on the end of the cartridge was likely worn so I said no problem. I took both cartridges out and replaced the rubber washers (they did look ok but had a circular indent on them, I assume where they seat)
After reinstalling the cartridges, only the tiniest dribble of water comes out of the tap for either hot or cold. If I pull either cartridge and turn on the stop in the cabinet, loads of water comes out the hole the cartridge was in.
Ideas???
After reinstalling the cartridges, only the tiniest dribble of water comes out of the tap for either hot or cold. If I pull either cartridge and turn on the stop in the cabinet, loads of water comes out the hole the cartridge was in.
Ideas???