I am wrapping up a small bathroom remodel project and am at the point where I can install the vanity and sink plumbing. The vanity was a custom build and is a small single sink type consisting of a single drawer on the bottom and cabinet doors above (laid out like french doors). Unfortunately the bottom drawer was constructed too high (my measurement error) such that the existing plumbing trap can not fully drop to its correct position. In other words, the low point of the trap hits the top of the drawer before I can full rotate it to the correct position. I think I need another inch of clearance, but I am definitely stuck with the vanity dimensions.
Is there anything I can do here? Can I purchase a more shallow trap? Thanks for your help.
Is there anything I can do here? Can I purchase a more shallow trap? Thanks for your help.