Hi,
I have a new Danze faucet I want to install on a wall-mount sink. The faucet came with braided supply lines. I would like to replace them with conventional 3/8 chrome hard line since the plumbing is exposed.
This is one of the supply hoses. On one end is the standard 3/8 compression style fitting with an O-ring; on the faucet side is this:
Is this a standard fitting?
Shown with 3/8 tube for scale:
The threaded portion is 1/8 NPT or nearly so (I can't tell if it is actually tapered or not).
I tried asking Danze how to do this and they sent me a new set of supply hoses and a couple 1/2 IPS to 3/8 IPS reducers. An "A" for effort, but no so good on the reading comprehension.
I have a new Danze faucet I want to install on a wall-mount sink. The faucet came with braided supply lines. I would like to replace them with conventional 3/8 chrome hard line since the plumbing is exposed.
This is one of the supply hoses. On one end is the standard 3/8 compression style fitting with an O-ring; on the faucet side is this:
Is this a standard fitting?
Shown with 3/8 tube for scale:
The threaded portion is 1/8 NPT or nearly so (I can't tell if it is actually tapered or not).
I tried asking Danze how to do this and they sent me a new set of supply hoses and a couple 1/2 IPS to 3/8 IPS reducers. An "A" for effort, but no so good on the reading comprehension.