Scott99
New Member
- Messages
- 33
- Reaction score
- 0
- Points
- 0
okay, so I get my new therm mixer soldered in, out of the top port up about 6in a valve. no pipe yet on the output side. the valve has the plastic rough in depth extension install. the mixer has threaded ports.
I'm on a ladder working on shower head fitting and while getting down I wack the plastic extension pretty hard with my knee.... I'm sure it flexed the pipe to some point, and now I'm worried that I stressed or fractured the joints and may get a leak. Its been under pressure for two days and so far so good.
Is this something I should be concerned with and should redo that section, or just consider it stress tested and move on??
I'm on a ladder working on shower head fitting and while getting down I wack the plastic extension pretty hard with my knee.... I'm sure it flexed the pipe to some point, and now I'm worried that I stressed or fractured the joints and may get a leak. Its been under pressure for two days and so far so good.
Is this something I should be concerned with and should redo that section, or just consider it stress tested and move on??