Chris4x4Gill2
New Member
I am trying to install a new tub fauct (spicket?) The old trim piece was held in place to the smooth copper pipe using a set screw. The new trim piece requires a threaded end and needs to be about 2" longer.
I am trying to braze (solder?) connector - short piece of pipe - threaded end onto the existing pipe where it comes out of the wall but so far I have been unable to get it to hold the solder doesnt want to penetrate, it builds up at the joint.
Any tips or ideas what I am doing wrong?
I am trying to braze (solder?) connector - short piece of pipe - threaded end onto the existing pipe where it comes out of the wall but so far I have been unable to get it to hold the solder doesnt want to penetrate, it builds up at the joint.
Any tips or ideas what I am doing wrong?