Kiko
Member
I'm thinking of replacing my old soldered-on toilet shut-off with a Sharkbite - available at HD.
Once I've cut out the old valve with my tubing cutter:
How much of a stub-out is needed for the Shark to slip over?
How should I prep the stub-out (remove any residual solder, etc.)? Emery cloth?
Do these things leak over time?
TIA
Once I've cut out the old valve with my tubing cutter:
How much of a stub-out is needed for the Shark to slip over?
How should I prep the stub-out (remove any residual solder, etc.)? Emery cloth?
Do these things leak over time?
TIA