KamakazyPlumber
New Member
I am T-splicing into an existing 1 "service line from a shared well. It serves two residences and I am adding a small 900SF house to the system. I believe the existing in ground poly is SIDR 11. I am going to use the same size pipe and t connect it with brass, barbed connectors. The pressure from the tank in the pump house is 60/40 so 160 psi pipe should do. I don't think I need SIDR 7 since this is on the low pressure side of the tanks.. I did use SIDR 7 on the well side of the line at my daughters house when I built it.
It is about 300 ft from ea. residence to the pump house.
Does make good sense or should I use thicker pipe and ford type compression connectors?
Thanks
It is about 300 ft from ea. residence to the pump house.
Does make good sense or should I use thicker pipe and ford type compression connectors?
Thanks