Pghsebring
DIY Member
Had a clay elbow break just as the stack was entering the floor.
I sawed up my floor, took elbow out. Went to use a rubber donut and 3" pvc - damn hub broke on next piece.
Got out hammer, grinder, etc, had to cut back another 15".
This is now what it looks like:
How do i attach to this? OD is 5", ID is 3.75". I don't care if i use 3" or 4" pvc from this point on. I'm not trying to hammer another donut in and break it again. Do i have to use a shielded fernco, or can i use an unshielded one? What part number, if you know off the top of your head? Or something else altogether?
I sawed up my floor, took elbow out. Went to use a rubber donut and 3" pvc - damn hub broke on next piece.
Got out hammer, grinder, etc, had to cut back another 15".
This is now what it looks like:
How do i attach to this? OD is 5", ID is 3.75". I don't care if i use 3" or 4" pvc from this point on. I'm not trying to hammer another donut in and break it again. Do i have to use a shielded fernco, or can i use an unshielded one? What part number, if you know off the top of your head? Or something else altogether?
Last edited by a moderator: