There is very little information on the web about this system, but I understand that this system do not use air in the pressure-tanks to make pressure, but is electronical controlled when the pump shall start and stop. Correct?
I live in Norway and I have not got any who can recognise the system for me here, and this is a US based forum? Anyway, I saw one post here where a man wrote that he would replace his Jacuzzi Hydrocel pressure tanks, so then I assume this system has been sold in the US too.
After I cleaned the tiny hole (who was nearly stuck) were the the water shall go thru to press on the membrane in the pressure switch, then the pump goes only for about a second, then it takes a break for about half a minute, and this repeats until the set pressure is achieved. Why is so? Can the system be reset in any way? Because no matter how I now turn up or down the small screw in the pressure switch (which I understand is supposed to regulate the interval the pump kicks in), does not change the interval the pump kicks in.
I live in Norway and I have not got any who can recognise the system for me here, and this is a US based forum? Anyway, I saw one post here where a man wrote that he would replace his Jacuzzi Hydrocel pressure tanks, so then I assume this system has been sold in the US too.
After I cleaned the tiny hole (who was nearly stuck) were the the water shall go thru to press on the membrane in the pressure switch, then the pump goes only for about a second, then it takes a break for about half a minute, and this repeats until the set pressure is achieved. Why is so? Can the system be reset in any way? Because no matter how I now turn up or down the small screw in the pressure switch (which I understand is supposed to regulate the interval the pump kicks in), does not change the interval the pump kicks in.