can00k
New Member
Hi everyone,
I purchased a tank with a Fleck 5600SXT a few years ago and it's been working great until the past week. The display used to cycle through the time and a number that I assume was the amount of water to pass through the tank until the next regeneration cycle. However, I don't believe a regeneration cycle has happened for the past week or more, and the display only shows "RC - 125" and the number continues to grow. I know RC stands for reserve capacity, but the manuals I'm reading all show that this should only be displayed if I'm reconfiguring the device, which hasn't been done in years.
Should I force a regeneration cycle or is there something else I should check?
Current info that I had documented previously:
155 ppm = 155 mg/L = 9 grains per gallon
capacity = 15.0 x 1000 (15000 grains)
hardness = 9 grains per gallon
DF = G
VT = df2b
CT = Fd
NT = 1
C = 15 x 1000
H = 9
RS = SF
SF = 10
DO = 7
RT = 2:00am
B1 = 10
BD = 60
B2 = 5
RR = 10
BF = 2
FM = t0.7
I purchased a tank with a Fleck 5600SXT a few years ago and it's been working great until the past week. The display used to cycle through the time and a number that I assume was the amount of water to pass through the tank until the next regeneration cycle. However, I don't believe a regeneration cycle has happened for the past week or more, and the display only shows "RC - 125" and the number continues to grow. I know RC stands for reserve capacity, but the manuals I'm reading all show that this should only be displayed if I'm reconfiguring the device, which hasn't been done in years.
Should I force a regeneration cycle or is there something else I should check?
Current info that I had documented previously:
155 ppm = 155 mg/L = 9 grains per gallon
capacity = 15.0 x 1000 (15000 grains)
hardness = 9 grains per gallon
DF = G
VT = df2b
CT = Fd
NT = 1
C = 15 x 1000
H = 9
RS = SF
SF = 10
DO = 7
RT = 2:00am
B1 = 10
BD = 60
B2 = 5
RR = 10
BF = 2
FM = t0.7