This weekend I am going to cut out a section of 3 inch underground ABS out of a hole I cut under my slab to insert a Wye.
My question is is there any easy way to make sure I get a straight cut? If I don't get it 100% straight I don;t think the banded no-hubs I have will seal correctly since they seem to want a 1/4 inch gap
Any easy way to make sure the cut is straight? Maybe use raditator clamps?
Thanks!!!
My question is is there any easy way to make sure I get a straight cut? If I don't get it 100% straight I don;t think the banded no-hubs I have will seal correctly since they seem to want a 1/4 inch gap
Any easy way to make sure the cut is straight? Maybe use raditator clamps?
Thanks!!!