bet3z
New Member
- Messages
- 27
- Reaction score
- 1
- Points
- 3
I've got a lot packed in under my kitchen sink, and I need to cram in a reverse osmosis filter. The painful part appears to be fitting the tank. The drain tailpiece from the left hand sink bowl comes down to an elbow that goes over to the tee shown in the attached image. The tank is huge, and placed where I need to have it, it would be in the way.
If I raised the tee up and went straight out of the disposal, the elbow from the left side drain tailpiece would just clear the tank. I suppose I could also reorient the tee so the inlet that comes in from the left would come in from above. The left side drain could come down, elbow over, and then elbow down to the tee.
I'm not sure what's preferable, if the pieces exist to do what I'm proposing, or if there would be an even better way to do it.
Thanks in advance for the help!
If I raised the tee up and went straight out of the disposal, the elbow from the left side drain tailpiece would just clear the tank. I suppose I could also reorient the tee so the inlet that comes in from the left would come in from above. The left side drain could come down, elbow over, and then elbow down to the tee.
I'm not sure what's preferable, if the pieces exist to do what I'm proposing, or if there would be an even better way to do it.
Thanks in advance for the help!
Last edited: