final touch
New Member
- Messages
- 4
- Reaction score
- 0
- Points
- 0
i have seen lots of these questions,i recently redid the plumbing to my well,shallow well since then lots of air in system.what is the best way to troubleshoot a leak on the suction side,i let the pump run and have sprayed every joint with soapy water,hoping to seeor hear it suck in.no luck.i only had to replace about 3' of pipe but i can,t see any problems,also my check valve is right at the inlet of the pump is this ok,and could it cause a problem if is bad.i had no well problems before.would letting the pump run and then coating fittings with glue be of any use??