Good morning! So, I purchased a Fleck 5600 SXT online and just installed it two evenings ago. Got most of it done right. Shut off the water, drained it, cut out the old one, installed the new one. Where I realized I missed the directions was in the actual opening up of the new softener bypass valve. I turned it slowly for about 30 seconds, but then I just opened it to service all the way, letting the tank fill. Two days later, I still have milky water throughout the home (all those tiny air bubbles) and the occasional spitting at the kitchen faucet. Did I harm the system, or is this an easy fix?
Thanks,
Steve
Thanks,
Steve
Last edited by a moderator: