J Blow
Member
I'm replacing an old standard tub with a 2 piece freestanding tub so purchased a Maax F2 drain system where you install a receptacle type piece in the floor where you can leave a tailpipe like piece on the tub and just drop it into the drain.
My problem is that this unit, where it connects to the P trap under the floor, is now a few inches lower than the drain line. Usually the drain line 90s to the p trap, which sits below the tub obviously but I'm needing to add a few inches down between the 90 and the trap which will make the trap about 3-4 inches lower than the drain line than it was before. Doesn't seem like it would be a problem but maybe I'm missing how it changes, the pressure, flow rate, etc...?
My problem is that this unit, where it connects to the P trap under the floor, is now a few inches lower than the drain line. Usually the drain line 90s to the p trap, which sits below the tub obviously but I'm needing to add a few inches down between the 90 and the trap which will make the trap about 3-4 inches lower than the drain line than it was before. Doesn't seem like it would be a problem but maybe I'm missing how it changes, the pressure, flow rate, etc...?