PM5K
Member
This question is in regards to stop valves for a bathroom sink.
I'm used to seeing either one of the following:
Copper supply, use compression fitting
Galvanized Steel, use threaded fitting
The current configuration is a copper supply with a threaded brass (can't be copper right?) end soldered on.
So what exactly do I do with this, buy a threaded brass stop valve?
Thanks in advance!
I'm used to seeing either one of the following:
Copper supply, use compression fitting
Galvanized Steel, use threaded fitting
The current configuration is a copper supply with a threaded brass (can't be copper right?) end soldered on.
So what exactly do I do with this, buy a threaded brass stop valve?
Thanks in advance!