Pimbley
New Member
- Messages
- 20
- Reaction score
- 0
- Points
- 0
Sweated in my pb valve and three way diverter. Seems ok.
Hooked up the hot inlet and thought I'd check my solder joints on that side before I hook up the cold (in case of redo).
So, turned the water. No leaks, but when I turn the valve on not a drip either from the cold inlet (exposed) of via the diverter (normal path of water). The not pipe gets warm right down to the valve.
Is this because the valve is pressure balanced, senses there is zero pressure on the cold and stops the hot flowing completely. I'm impressed if so.
Or is this bogus and the valve must be broken?
Thx - Pimbley
Hooked up the hot inlet and thought I'd check my solder joints on that side before I hook up the cold (in case of redo).
So, turned the water. No leaks, but when I turn the valve on not a drip either from the cold inlet (exposed) of via the diverter (normal path of water). The not pipe gets warm right down to the valve.
Is this because the valve is pressure balanced, senses there is zero pressure on the cold and stops the hot flowing completely. I'm impressed if so.
Or is this bogus and the valve must be broken?
Thx - Pimbley