elbows

  1. G

    Kitchen waste pipe elbow

    Adding a new kitchen sink and ptrap to replace the rollercoaster PVC elbow situation in the cabinet, only to find more. I had planned to update with an aav inside the cabinet (even though I don't have venting issues specifically it seems like best practice) but did not expect to find that elbow...
  2. TheOverThinker

    Offsetting 1.5" galvanized on a 22.5 degree angle? How? Possible?

    To make room for a solar panel layout, I'd like to extend the following plumbing penetration to a spot higher on the roof. At this time I have access from above to the pipe embedded in the wall, and access to the roof below the 6" dimensional rafters. The roof pitch is 6:12, which means 22.5...
  3. Milesmoony

    Using hydraulic fittings as a last resort in home plumbing

    Hi, this is my first post here. I just finished replacing all of my plumbing and it all came out great, no leaks (2 sinks, 1 shower). I used pex piping with quick connect fittings and on demand hot water. I ran a hot a cold line with tee’s going to each fixture and I used the sharkbite faucet...
  4. Happy Tom

    Is this water softener installed correctly?

    Hello All, I recently replaced a 22 year old Culligan unit with a new unit featuring a Clack valve from a local water conditioning company. Please take a look at the pictures of the install, I'm wondering if he used the proper elbows for the diameter of piping, they seem to be smaller. Could...
Top