Search results

The vanity is 24" wide by 21" deep. The top is 25" wide by 22" deep. The vanity is set in a corner so the top overhangs one side by 1"+ and the front by 1"+. The top needs to be supported pretty much all the way to the edge. My plan is to rip 1x material that will serve as stable base for the...

This layout is for a small bathroom in an apartment with a garage underneath. Is this a good plumbing design that meets code (I've attempted to do so)? Or would it be better to tie the tub drain in closer to the 3" vertical stack? Any other suggestions?

I am rehabbing one of my apartments that sits above a garage and I have a situation where the a 4" cast iron soil stack in a garage has been cut flush with the concrete floor. The stack was already broken at garage floor level and therefore needed to be replaced. Unfortunately, since it was...

I'm installing a new Moen drop in sink. The countertop has been cut out according to the instructions. The issue is that there is no place in the front where the clips can grab onto (see photo). After cutting, the countertop just so happens to be flush with the cabinet top rail in the front...

Believe it or not I couldn't find any good info on this online. It's probably such basic knowledge to most plumbers, but as a DIY'er who hasn't worked with this type of supply line before, I want to be 100% sure I'm using the correct parts. Anyway, I am rehabbing 4 of my apartments over the next...