When it clicked on at 39 I am going to assume the pump was running I have no way of being positive as it’s down in the well outside, but the pressure in the tank goes up which I assume means it’s filling with water
The air pressure / water pressure is same
I don’t have the ability to know when this issue happens it’s only happened 4x that I’m aware of , The fact that I saw the gauge drop to zero was complete fluke it’s never done that since then… It’s very intermittent otherwise I would record it and...
Yeah there’s no banging, and I don’t have any air , As a matter fact when my previous tank valve would click on it would make a clicking sound while the pump filled the tank this one does not do any of that,The brief interruption has only occurred four times that I can be certain of , And it is...
Sorry for the delay in my reply series of unrelated events have kept me from getting back to this, I’ve spent a little bit of time watching the gauge , It appears it’s set at 40/ 60.. Comes on it looks like at about 38, but something interesting I’ve discovered is on one occasion When the pump...
Plumber said the diaphragm likely had a small tear, and that the tank was waterlogged .. it was on its way out so this was preemptive before other problems , I am hoping the precharge is the issue, as I have not had any other issues in the past. thanks for replying : )
Hi , I had a 27 yo pressure tank replaced as the previous one had a water trickle sound at the end of pumping, so I figured I better get it changed out... had a plumber do just that, changed tank, fittings valves etc..
3 times I have noticed now on different occasions while running bath water...
Hi, I am not familiar with all of the dynamics of vent pipes, but heres the scenario, please help me to understand what the culprit is....
We have an area on our bathroom wall( side of toilet ) that previously had a toilet paper holder attached, it had shown water type damage so we removed the...
Happy New Year,
I have had an issue with my well since we had an addition built that was in fairly close proximity to the well..(25ft), the ground apparently had been disturbed enough to cause some issues with our manganese increasing and small amounts of sediment, I an not sure exactly what...
Bumping this "old"post to ask another question …. its been 2 yrs now, and we have seen improvement in the pressure but the sediment / rust color on the filter is just as bad if not worse. I use a 5 micron 4" cartridge and within 1 week its covered in rust sludge … I have had ALOT going on in...