irrigation

Hi, I’m renovating my yard and reworking the irrigation layout. While tracing the system, I found multiple burst lines, and the existing piping was a complete mess which it took me weeks to map everything out. I also discovered that some PVC pipes cracked at the couplings, though I’m not sure...

He All, I’m looking to set up an irrigation system to water 3 acres of fruit trees, 2 acres of commercial flowers, and provide personal fire defense in Northern California. The water source is a pond (avg 6’ deep, 150’ across, and 20’ below the fields) fed a creek that goes dry from mid...

My first post here... "Hello"! Just moving into a new place and trying to get the irrigation system working. I had to replace a few of the heads, and made sure they were the same brand Toro. After finally getting all the heads fixed, there are some heads that are spraying perfectly, very fine...

I bought a house this year that has a 30ft well and 1hp Gould J10s pump with a 20ga pressure tank for the house. I need to add an irrigation system, and wanted to use the same well. I got a quote from a local company who said my well tested at 100 gpm, and recommended that I replace the pump...

I have appreciated the posts on this thread as I have planned my project. I live on a rural property that has a 30 foot dug well and a convertible jet pump that does a good job. However we run the risk of the well going dry in the summer. We also live 85 feet above a river that is down a...

Thank you in advance for your assistance. New lake home and looking to accomplish the following: I have a red lion rl-sprk100 pump. I would like to suck water from the lake 20' away from the pump and about 5' below the pump to a spigot location 20' away from the pump and about 10' above the...

The flow to one of my Rain Bird controlled yard irrigation flow paths continues to flow once it's turned on by the Rain Bird control box. If I disconnect the the wire at the control box, there is no flow. That's what I've done to keep it from running 24-7. What is the most likely cause? Should...

Hey there new to all this. I have a 15 gpm well in my pasture and my pressure tank is in my house 300' away. I am hoping to tee in very close to the well head and put a valve/spigot a couple feet away to water wine grapes 500' in the opposite direction and uphill 30 feet max. I've read that if...

I am replacing 30 yr old irrigation pump for my sprinkler system. Was a 1½hp Myers pump. Pump still running but think the body has just about rusted thru. I am looking at pumps in the $400 range and wondering if I should be looking at more expensive pumps but do not know what the advantage...

Sprinkler anti siphon lid on my Champion brass irrigation valve leaks (heavily) when this irrigation Zone is turned ON & none of my sprinklers pop out and they don't work in this zone.... It was working perfectly until this. The only thing I have recently done (not sure if relevant): Could the...

I have a five valve irrigation system. Four of the five work perfectly. One, when it "turns on" (in sequence, it is the third zone of the five) knocks/hammers unstoppingly until I shut off the zone. Since the system is at least 15 years old, I suspect that particular valve is the problem. I can...

Hello, I recently installed a pretty DIY outdoor irrigation setup. It has a 4- way splitter coming off the spigot that supports 2 sprinklers and 2 lines to the irrigation. And now I have air in my pipes which is causing issues with my washer and other things inside. I'm guessing it has to...

Hey everyone, I'm looking to get feedback on setting up my incoming house water line as: shutoff ball valve > water hammer arrestor > PRV I share a curb stop city main with my neighbor that has a lawn irrigation system hooked up on their side. I currently do not have a PRV and my pressure...

4 zones total on a Rainbird system. 2 zones are perfect and my pressure gauge runs at 40psi. 1 zone is not working and no resistance on the solonoid so pretty obvious there. Lastly, zone 2 is releasing some water but very low pressure at a shaky 20psi and can hardly lift a sprinkler head. Pump...

Hello all, I recently purchased a new home and began working on the landscaping and drip irrigation system. Aside from the many leaks, I discovered that anti-siphon valves had been installed below ground, in a box. Worse still, my property has extreme grade changes and 3 of the valves were...

I have a cheap DRUMMOND 1 HP Cast Iron Shallow Well Pump With Pressure Control Switch. I have 6 zones on a 1/4 acre lot with only 4-5 heads running at a time. The pump had not run in a few months and it was failing to prime so I called a sprinkler and irrigation company out to fix my...

Hi. I've used this forum often for my indoor plumbing issues but this is the first time I've tried it for an irrigation. Thank you in advance. I have an underground pvc pipe that feeds an outdoor faucet. I dug up the area and see the following (pictures attached): 1. PVC pipe goes into a...

I just had a drip system installed to water 9 large green giants, and 4 fruit trees--all on one zone--and planted pretty much in a line. The drip tubing goes around each plant a few times. I looked in the valve box and don't see any kind of pressure reducing valves. Considering our water...

I have an older 1 HP General Electric water pump that doesn't use a pressure tank and no longer works properly. It draws water from our lake and has worked fine until recently. The problem I'm getting is that the pump appears to be surging (runs at normal speed for a few minutes then slows down...

Hi all, I've had Rain Bird design an irrigation system for me, and I've taken it upon myself to work up the valve box...I'm not a fan of burying utilities, especially when I'm likely to need to replace pieces when they freeze (as I'm in a Northern Climate). Here is the picture of a basic...