(206) 949-5683, Top Rated Plumber, Seattle
Results 1 to 2 of 2

Thread: Installling shower base--frustrations!

  1. #1

    Angry Installling shower base--frustrations!

    I am finishing up a bathroom-finally getting to a 3ft square basement shower that was cracked at the bottom. After removing the base and buying a base to fit the shower, on pre installation I came to the grim reality that the drain hole and 2'' pipe drain in the concrete did not line up, in fact two inches off. Speaking with a local plumber I was told to line up the drains at all cost. That I did and installed the gasket drain and sealed it to the pipe.

    Three sides fit perfectly, but now I'm stuck with a 2'' gap that's seven inches deep (opposite the entering side) that I have filled with 2 2x4s for the seven inches. The big question: What can you cover this 36" x 2'' gap with to completely seal and waterproof the opening? Plastic, more fiberglass, sealant? (I don't want to spend another $100 bucks to buy another base)

  2. #2
    Retired Defense Industry Engineer jadnashua's Avatar
    Join Date
    Sep 2004
    Location
    New England
    Posts
    21,374

    Default

    The better answer is to move the drain line to line up. Or, you could make a traditional shower pan and tile it. I'm not a pro, but I can't think of a good way to fill thatopening and keep it waterproof, at least without spending a bunch. How's your fiberglass forming skils? You'd never get the finish to look like the existing walls, but you could bond that in. Very much of a hack, though. A picture would help. What exactly are the walls made of and how do they connect with the base?
    Jim DeBruycker
    Important note - I'm not a pro
    Retired Defense Industry Engineer; Schluter 2.5-day Workshop Completed 2013, 2014

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •