fromjusttheking
New Member
- Messages
- 4
- Reaction score
- 0
- Points
- 0
I am a newbie when it comes to wells and pumps. Our water pressure is not quite high enough at our 2nd floor shower using a 30/50 9013FSG2 Pumptrol pressure switch. I bought a new 40/60 Pumptrol switch, but there were no instructions at all enclosed. I am not sure as to the specific sequence to follow in replacing the switch.
In reviewing many of the postings, I didn't find any step-by-step instructions as to exactly what sequence should be followed in making the replacement. I don't want to screw up what is currently working, (with lower water pressure) by doing something stupid, like guessing how to do it.
Could some knowledgeable souls please provide step-by-step instructions on how to do it correctly? Will I have to set the large (and/or small) screw settings as well? I'm sure others like me new to this will benefit from your expertise and wisdom.
Thanks very much in advance for your help and this wonderful forum.
Alan
In reviewing many of the postings, I didn't find any step-by-step instructions as to exactly what sequence should be followed in making the replacement. I don't want to screw up what is currently working, (with lower water pressure) by doing something stupid, like guessing how to do it.
Could some knowledgeable souls please provide step-by-step instructions on how to do it correctly? Will I have to set the large (and/or small) screw settings as well? I'm sure others like me new to this will benefit from your expertise and wisdom.
Thanks very much in advance for your help and this wonderful forum.
Alan