MJCMendonca
New Member
Have been reading this site for quite a while and it was absolutely brilliant when installing my Toto Aquia 2 toilet a while back.
This is my first post though...
I am working on a bathroom renovation upstairs and I am now working on converting my previous single sink plumbing to a new double sink setup. I opened the wall to see what I am looking at, and took a picture so that you could see it too. (please see picture below).
My question is ... can I cut into the pipe on the left, which I believe is a vent (this is on the second floor and the attic is directly above this level) and run the drain for the left sink there? and leave the right pipe alone and plumb the right sink there?
Piping is all 1 1/2.
If that is not possible/recommended, would you please provide other options?
Again, thank you very much for your help.
Mo Mendonca
ON, Canada
This is my first post though...
I am working on a bathroom renovation upstairs and I am now working on converting my previous single sink plumbing to a new double sink setup. I opened the wall to see what I am looking at, and took a picture so that you could see it too. (please see picture below).
My question is ... can I cut into the pipe on the left, which I believe is a vent (this is on the second floor and the attic is directly above this level) and run the drain for the left sink there? and leave the right pipe alone and plumb the right sink there?
Piping is all 1 1/2.
If that is not possible/recommended, would you please provide other options?
Again, thank you very much for your help.
Mo Mendonca
ON, Canada
Last edited by a moderator: