crazyweazle
New Member
Lately we've had problems with the water stopping if the washing machine is using both hot and cold water, of if you flush the toilet while running hot water in the bath tub. It sometimes will stop for a minute or more. I replaced the pressure switch and gauge, also made sure the air pressure in the bladder is 2 lbs below the cut on pressure. Even with the new pressure switch, it delays clicking on after the pressure drops below the cut on pressure. Once the pump cuts on, the pressure quickly rises and continues to rise 20 to 40 lbs above the cut off pressure, even tho the pump actually cuts off at the correct pressure. (I figure this is not uncommon tho.) I have a deep well submersion pump of unknown age, we have lived here for 15 yrs.
Any advice would be greatly appreciated!
Any advice would be greatly appreciated!