Fleck 90deg adapter?

70runner

New Member

Messages

19

Reaction score

0

Points

1

Location

Fallbrook, CA

• Sep 28, 2013

• #1

My 9100SXT twin tank install needs to be close to the wall. I found a 3/4" adapter for the 9100 here, unfortunately my supply line is 1". Would this work or does Fleck have a 1" 90 adapter?

 

Mialynette2003

In the Trades

Messages

944

Reaction score

17

Points

18

Location

Ocala, Florida

• Sep 28, 2013

• #2

You could use this http://www.softenerparts.com/SearchResults.asp?Search=18706&Submit= or this http://www.softenerparts.com/SearchResults.asp?Search=13398&Submit=

 

Sponsor

Paid Advertisement

• 1 minute ago

• Add bookmark
• ##

 

70runner

New Member

Messages

19

Reaction score

0

Points

1

Location

Fallbrook, CA

• Sep 28, 2013

• #3

Not sure how those would solve my prob. Looking for a 90 elbow yoke assembly, a 1" version of this:

 

Mialynette2003

In the Trades

Messages

944

Reaction score

17

Points

18

Location

Ocala, Florida

• Sep 29, 2013

• #4

I mis-understood. Thought you where looking for 1" adaptors to connect piping to the 90 deg yoke.

 

70runner

New Member

Messages

19

Reaction score

0

Points

1

Location

Fallbrook, CA

• Sep 29, 2013

• #5

No problem. I was basing my question on the valve I'm familiar with, the Fleck twinflo, where it opens to the rear. I assumed the 9100 did also, but apparently it opens to the side which solves my wall proximity issue.