Hi all
What is the best to calculate the depth to install the rough in valve for a shower handle? How accurate do we need to be?
In my old shower, tiles was installed over a cement wall (with a lathe) which was attached to green boards. I would say both add up to about 1" of thickness.
I took it down to stud and I plan to install tile on a 1/4" cement board.
Do I need to push the valve further in the wall or the shower handle trim can compensate for that?
Thank you
What is the best to calculate the depth to install the rough in valve for a shower handle? How accurate do we need to be?
In my old shower, tiles was installed over a cement wall (with a lathe) which was attached to green boards. I would say both add up to about 1" of thickness.
I took it down to stud and I plan to install tile on a 1/4" cement board.
Do I need to push the valve further in the wall or the shower handle trim can compensate for that?
Thank you