I am purchasing a new Toto Drake based on the recommendations here. However I was a tad confused about the requirement of using two wax rings based on flange height.
Currently my bathroom tile is cut to run right up flush to the flange. The construction was done before me, I just removed the old junk toilet. The flange might (I cant tell for sure) be a MM or two below the tile top surface. I read on another thread here that you have to use two wax rings in this situation to insure a good seal. My concern is how do you make sure when you stack two wax rings that you dont have "gunk" squeeze into the waste flow path?
I want to make sure I do this correct as its on an upper floor and while I dont leave in Wa, its seems like good sense to leave the caulk off the back side of toilet foot to allow leaks to show up.
Could someone give me a tad more guidance in this matter?
Thanks!
-Bearcats
Currently my bathroom tile is cut to run right up flush to the flange. The construction was done before me, I just removed the old junk toilet. The flange might (I cant tell for sure) be a MM or two below the tile top surface. I read on another thread here that you have to use two wax rings in this situation to insure a good seal. My concern is how do you make sure when you stack two wax rings that you dont have "gunk" squeeze into the waste flow path?
I want to make sure I do this correct as its on an upper floor and while I dont leave in Wa, its seems like good sense to leave the caulk off the back side of toilet foot to allow leaks to show up.
Could someone give me a tad more guidance in this matter?
Thanks!
-Bearcats