Pete C
Member
I have a vaughn indirect water heater and an armstrong astro 50 circulator pump.
Last week I was in the basement diagnosing a bad air vent. Anyway, after reinstalling the vent and purging everything, I shut the boiler feed off....and forgot to turn it back on.
A few days later my wife says "what's that noise coming from the basement. I went down and saw that the circulator was making a racket. I then noticed the boiler feed shut off.
Whoops.
Turned it back on, purged the system and crossed my fingers, hoping I didn't ruin the circulator by running it dry. All seemed well, other than the circulator now being a little louder.
A few days later....no hot water. Went down, looked it over. Unscrewed the cap out of the end of the circulator motor and it was spinning and water leaked out. Not sure if this is normal or a sign of a bad seal. I took the pump off, dangled it in a bucket of water and turned it on. Good strong flow. So, I put it back together, purged it all again and the water heater came back. Hot water for a few days. Now we are back to square one. The pump is spinning, but, awfully quiet and no apparent flow.
One thing that seems odd is when I shut off the boiler return and open the valve just upstream from this faucet, the circulator seems to slow down as if all of a sudden, it has something to pump. But after awhile it speeds up again. Is it possible that there is a seal leak that is causing the circulator pump to draw air causing it to lose it's prime? I can't hear it. I held a just put out match under it and watched the smoke looking for a sign of airflow, but there is none.
I fear I may have to spring for a new pump. Is this model armstrong pump rebuildable? It is the astro 50.
Thanks
Pete
Last week I was in the basement diagnosing a bad air vent. Anyway, after reinstalling the vent and purging everything, I shut the boiler feed off....and forgot to turn it back on.
A few days later my wife says "what's that noise coming from the basement. I went down and saw that the circulator was making a racket. I then noticed the boiler feed shut off.
Whoops.
Turned it back on, purged the system and crossed my fingers, hoping I didn't ruin the circulator by running it dry. All seemed well, other than the circulator now being a little louder.
A few days later....no hot water. Went down, looked it over. Unscrewed the cap out of the end of the circulator motor and it was spinning and water leaked out. Not sure if this is normal or a sign of a bad seal. I took the pump off, dangled it in a bucket of water and turned it on. Good strong flow. So, I put it back together, purged it all again and the water heater came back. Hot water for a few days. Now we are back to square one. The pump is spinning, but, awfully quiet and no apparent flow.
One thing that seems odd is when I shut off the boiler return and open the valve just upstream from this faucet, the circulator seems to slow down as if all of a sudden, it has something to pump. But after awhile it speeds up again. Is it possible that there is a seal leak that is causing the circulator pump to draw air causing it to lose it's prime? I can't hear it. I held a just put out match under it and watched the smoke looking for a sign of airflow, but there is none.
I fear I may have to spring for a new pump. Is this model armstrong pump rebuildable? It is the astro 50.
Thanks
Pete