JonnyTar
New Member
I just moved into an older home and had a new electric hot water tank installed. Everything went very smooth and tested good after the install. Took a shower the next morning and water ran out after @ 12 minutes. Checked the pressure gauge and noticed it was at "0" and the Pumptec unit was "tripped". I messed around with the Pumptrol controls and am afraid that I turned them both too many times in so many directions - now I have no idea where the Pumptrol settings are and the Pumptec unit will not turn back "on".
Please assist me with some good troubleshooting from this point! Thank you
Please assist me with some good troubleshooting from this point! Thank you