My house is hooked up to rural water. The pressure of the water is about 82 psi. When we moved into the house, we notice some water hammer, but after a new dish washer was installed, it has gotten worse. Almost any fixture will cause the water hammer to some extend. I bought a small pressure tank and installed it where the water comes into the house. I was hoping this would solve the water hammer for the entire house. It didn't. The water comes in and goes to a water softner, then a hot water heater and so on. I've tried putting the pressure tank at different pressures to see if that changed anything and it didn't. Any advice on what to do? Is there a whole house solution or do I have to put an arrestor/air chamber on each faucet?
Thanks
Chris
Thanks
Chris