Gdunbar
New Member
- Messages
- 20
- Reaction score
- 0
- Points
- 0
I am replacing a shower with a bath/shower. The supply lines will need to be dropped a few feet and I need to install the Tub spout. Currently the vent is right in the way if I were to lower the lines. The vent comes up about 4 feet then takes a 90 degree turn left to the stack. The vent is like 3inch steel/iron. Is there any issue if I were to take the vent down to like a 16 inches, then have it go 90 degree left and onto the main stack? Or even like a Z back up to the original tie into the stack?
PLumbers come tomorrow for the big saw cut in the floor for the relocate of the toilet. Will be messy.Thanks
PLumbers come tomorrow for the big saw cut in the floor for the relocate of the toilet. Will be messy.Thanks